Oozi – I hate Oozi

I need to mess with the PID loop on the 3D printer. Right now it’s got about 12 possible temperature states in a look-up table, and that’s not enough. It needs 60, I think. The symptom is that the print never starts, and I believe that’s because the temperature never stabilises enough. If the change in loop doesn’t fix it, I’ll end up using an Arduino/Ramps combo, but I need to do this.

I’ve needed to do it for about five months now. I do not want to flash that damned thing Yet Again. For one thing, it’s been months since I have and I’ve forgotten most of the steps.

Update: Have accidentally ordered an Arduino Mega to go with the early RAMPS board I picked up. I was on eBay and it fell into my basket.

Leave a Reply

Your email address will not be published. Required fields are marked *